Erwin XL building Instruction
September 2008
9. Installation of antenna
As ErwinXL is completely made of carbon, a part of the
antenna must be situated outside the model.
One possiblity is to „extend“ the fuselage at the rear end
with a steel wire of about 450mm. Fix the end of the
antenna to this steel wire.
Another solution is to fix the antenna to the end of the
elevator. Lead the antenna inside the fuse behind the
wing and then leave the fuselage. You should add the
length between receiver and the breakthrough of the
fuselage to the end of the antenna, so that the original
length of the antenna is completely outside the fuselage.
Always test the reception on ground before you fly!
www.pcm.at
12