Erwin XL building Instruction
September 2008
8. Wing
Use the wooden frames enclosed for the installation of the
servos Hitec HS-125 und HS-5125.
Lead the cable through the wing as shown below.
The connection to the levers on the rudder goes crosswise
through the wing.
Before you glue the lever to the rudder, mill a slit of about
10mm in the rudder as shown on the picture to the right.
Flap Aileron
For gluing the lever use epoxy-glue with cotton flocks.
When fitting the lever in the correct position, notice that the
hole in the lever should be situated vertically above the
hinge line.
www.pcm.at
10