© PCE Instruments
27
Manual Stepping
To Enable Manual Stepping, select Source Type as STEP and Check the Manual CheckBox.
If this mode is enabled, icon will appear in Source Display Window in RUN Page.
Pressing UP or DOWN key in RUN Page will Increment or Decrement Source Value by Step
specified in STEP Page.
In RUN Page, Source Value can directly change by Pressing F1 key (EDIT) and modifying value
like in EditBox. And STEP Setting can be accessed directly by F2 key (SETTING).
Auto Stepping
To Enable Auto Stepping, select Source Type as STEP & UnCheck the Manual Check Box.
If this mode is enabled,
(Step UP) or
(Step Down) icon will appear in Source Display
Window in RUN Page and F1 & F2 Button change to START and SETTING respectively.
Automated Step can be started by Pressing F1 key (START). After that F1 and F2 key will change
to PAUSE&STOP respectively. So by pressing F1 & F2 key running STEP can be PAUSE or
STOP at any time in RUN Page.
STEP Setting can be accessed directly by F2 key (SETTING).
NOTE: While STEP is running STEP settings can’t be accessible and Source Page Parameter
settings can’t be change. Stop STEP before changing any settings.
