Manual
11
Note:
1. The users may enter maximum 5 digits.
2. If you enter a temperature value (incl. digits after the decimal point), and then press ENTER, the
PCE-789 outputs this temperature value.
3. If the output value is < 0, please, enter the minus first.
4.
If the output value is < 1 and > 0, please, enter “0” first.
Warning
:
1. Do not connect any current carrying conductor or a loaded circuit to the TC jacks in order to avoid
the damage of PCE-789.
2. If there is a short circuit or an overload at the output jacks, the PCE-789 cannot show any correct
voltage value. Disconnect the device and check, whether an OUTPUT ERROR symbol is
displayed.
3. Always make only one measurement at the same time and connect only the sockets required for
this. Disconnect all the unused sockets. Connect the measuring cable always only to one socket
type (SOURCE or MEASURE or TC).
b) Setup Instructions
(1) Press SETUP to enter the SETUP menu.
(2) TC 0%: sets the temperature starting value of the ramp function (d
etails in the chapter “Ramp
function”)
(3) TC 100%: sets the temperature end value of the ramp function (d
etails in the chapter “Ramp
function”)
(4) C. J. COMP.: sets the CJC.
(5) TC TYPE: sets the thermocouple types.
(6) UNIT: here you can choose between °C and °F.
