MULTICHANNEL SIGNAL CONDITIONER MODEL 482C27 GENERAL OPERATION MANUAL
25
Important Note: The communication protocol requires a unit id as part of the command header. The unit id is
not the IP address. To send commands to the unit via Ethernet you must address the TCP-IP packets with the
proper IP address and ensure the packet payload contains the correct Unit Id in the command header.
The Lantronix device will be PCB factory set with the proper communication parameters. Some of these parameters
though are not the default parameters of this device. In the screens that follow, the fields pointed to with arrows are the
modified parameters. Should you need to change them or want to check them if you are experiencing communications
problems the following screens will show how it is done.
Note: Port 10001 is the port selected for remote Ethernet communications.
To gain access to the Ethernet and serial parameters click on an IP address in the left pane and then on the Web
Configuration tab in the right pane as shown below. Then click on the
GO
button.
This will cause the Login Dialog screen to appear (also below). No entry is required since our devices are not factory
protected, click
OK
.
