Brighten Your Digital View!
9
www.pbi-china.com
7.2.2 Configure
Main-Menu Sub-Menu1
Sub-Menu2
Sub-Menu3
Description
Configuration
Tuner
Setup
Tuner
1/2/3/4
LNB Frequency
LNB Frequency
Satellite Frequency Satellite Frequency
Symbol Rate
Setting Symbol Rate of Tuner1/2/3/4
LNB Voltage
switch OFF/13V/18V
LNB 22KHz
ON/OFF
DiSEqC OFF/Port
A/Port B/Port C/Port D
Remux
Remux
Setup
Program Select
select the programs to remux. Click on Enter
to select, double click to cancel. (The
program(s) will be marked with an asterisk (*)
once be selected)
Select
SPTS
from
Tuner 1 ~ 4
IP Input:select the program(s) inputted via IP
input port. (Note: this sub-menu is displayed
only when the IP I/O is configured as
full-duplex mode.)
Bit Rate
Output Bit Rate: key in the bit rate of the
newly generated MPTS, valid range from
100K~216000 Kb/s
Packet Size
188 Byte/204 Byte
TS ID
TS ID: key in the TSID of the newly
generated MPTS, valid range from 0 to
65535 decimal
Remove CA
ON/OFF:
Insert EIT
ON/OFF:
Output Program
display the remux program
TS/IP
Gigabit
Output
Gigabit Out Switch Enable/Disable
Sourse
Tuner1~4 Remux TS IP IN
Protocol
UDP: set UDP protocol to IP output
RTP: set RTP protocol to IP output
TS Pkts Per UDP
set the number of TS packets that can be
carried by each UDP packet, valid range from
1~7
Time To Live
set TTL to the output IP packets, valid range
from 1~255
Type Of Service
Min Delay/Max Reliability/Max
Throughput/Min Monetary Cost/Normal
Uni/Multi IP Address set the destination IP address