For errors 751-753, Check the
F
supply tracking
F
supply marks
F
black mark sensor position
F
supply roll for binding.
Press the FEED button and try to continue printing. If
the error continues to appear, change the supply.
752
Printer sensed a mark in the wrong place.
753
Printer sensed a mark that is too long.
754
Printer has a ribbon problem. Check the ribbon for a
jam or remove any slack by turning the take-up reel
clockwise. Load a new ribbon.
755
Printhead is open. Close the printhead before
continuing. If the error persists, call Technical Support.
756
The printer is out of supplies. Load supplies.
757
Load supplies. The calibrated supply length differs by
plus or minus .25 inches from the format. Press the
FEED button to print on the current supply or load new
supply and press the FEED button.
758
Check supply. Either the supply is not seen or the
on-demand sensor is broken. Check for a label jam.
Clear the supply path or reload supplies. This error
may occur if you remove a label too quickly in
on-demand mode. The printer does not recalibrate
after this error.
759
Knife is not moving. Call Technical Support.
760
Knife jam. Call Technical Support.
9-14
Errors
Summary of Contents for Monarch 9412
