1. Configure IP address
46
SmartNode 4830 Getting Started Guide
4 • Getting started with the SmartNode
Login
Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to display.
Type the factory default login: administrator and leave the password empty. Press the Enter key after the pass-
word prompt.
login:administrator
password: <Enter>
172.16.40.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as command line
prompt. With the commands enable and configure you enter the configuration mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#
Changing the IP address
Select the context IP mode to configure an IP interface.
172.16.40.1(cfg)#context ip product
172.16.40.1(ctx-ip)[product]#
Now you can set your IP address and network mask for the interface eth0. Within this example a class C net-
work (172.16.1.0/24) is assumed. The IP address in this example is set to 172.16.1.99 (you should set this to
an unused IP address on your network).
172.16.40.1(ctx-ip)[product]#interface eth0
172.16.40.1(if-ip)[eth0]#ipaddress 172.16.1.99 255.255.255.0
2002-10-29T00:09:40 : LOGINFO : Link down on interface eth0.
2002-10-29T00:09:40 : LOGINFO : Link up on interface eth0.
172.16.1.99(if-ip)[eth0]#
Copy this modified configuration to your new start-up configuration. Upon the next start-up the system will
initialize itself using the modified configuration.
172.16.1.99(if-ip)[eth0]#copy running-config startup-config
172.16.1.99(if-ip)[eth0]#
The SmartNode can now be connected with your network.
Summary of Contents for SmartNode 4830 Series
Page 52: ...52 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 53...
Page 81: ...81 Appendix E SmartNode 4830 Series factory configuration Chapter contents Introduction 82...
Page 83: ...83 Appendix F Installation checklist Chapter contents Introduction 84...
Page 85: ...85 Appendix G Accessories Chapter contents Introduction 86...