![background image](http://html2.mh-extra.com/html/patton-electronics/smartnode-4830-series/smartnode-4830-series_getting-started-manual_4099493036.webp)
Installing the VoIP IAD
36
SmartNode 4830 Getting Started Guide
3 • Hardware installation
Figure 15. Connecting a SmartNode 4830 Series device to a hub
Installing the serial WAN cable
The SmartNode 4830 Series is available with the following serial interfaces):
•
DSL (RJ11)—See section
“Installing the DSL interface cable”
on page 37 for details on installing the inter-
face cable
•
V.35 (DB-25)—See section
“Installing the V.35 interface cable”
on page 37 for details on installing the
interface cable
•
X.21 (DB-15)—See section
“Installing the X.21 interface cable”
on page 38 for details on installing the
interface cable
•
T1/E1 (RJ48C connectors)—See section
“Installing the T1/E1 twisted pair cables”
on page 39 for details
on installing the twisted pair cable
•
E1 (Dual coaxial connectors)—See section
“Installing the E1 dual coaxial cables”
on page 40 for details on
installing the coaxial cables
Hub
Straight-through cable
SmartNode: RJ-45, male
Tx+
Tx-
Rx+
Rx-
1
2
3
6
Hub/switch: RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
Summary of Contents for SmartNode 4830 Series
Page 52: ...52 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 53...
Page 81: ...81 Appendix E SmartNode 4830 Series factory configuration Chapter contents Introduction 82...
Page 83: ...83 Appendix F Installation checklist Chapter contents Introduction 84...
Page 85: ...85 Appendix G Accessories Chapter contents Introduction 86...