Patton electronics ipRocketLink 3086FR, User Manual

Page: 170 / 172

Administering user accounts 170
Model 3086FR ATM IAD User Guide E • Command Line Interface (CLI) Operation
Example: To read the attribute ‘Version’:
gshdsl show Version
To set data rate to 256K (4 * 64K):
gshdsl set DSLRateTS
To set terminal type to CPE mode:
gshdsl set terminal remote
To show the current terminal type:
gshdsl show terminal
To establish the DSL link
1. One unit needs to be set to CO (central) and the other unit as CP (remote)
2. The Data rate of the 2 units have to be the same (DatarateN)
3. The interface type needs to be the same to pass data (Interface)
4. Issue the ‘Action’ command to start the handshaking process (Action Start)
Example: To set up the units to run at 2.048Mbps using ATM interface.
For CO (central) unit
fi
gshdsl set terminal central
fi
gshdsl set interface utopia
fi
gshdsl set dataRateN 32
fi
gshdsl set dataRateI 0
fi
gshdsl set Action Start
For CPE (remote) unit
fi
gshdsl set terminal remote
fi
gshdsl set interface utopia
fi
gshdsl set dataRateN 32
fi
gshdsl set dataRateI 0
fi
gshdsl set Action Start
Attribute Type Value Description
Version RO - The version number of the DSL driver
Platform RO - The platform name of the unit e.g. 3086FR or 3086FR
ModemState RO Idle
Deactivated
Norm Oper
In-Progress Show the state of the handshaking process:
Idle – The DSL chip is in idle state
Deactivated – The DSL chip is deactivated
Normal Operation – The DSL chip is in operating (Link established)
In-Progress – Handshaking in process
DSLRateTS RW 3-36 Data rate N number N=3-36. e.g. 256K data rate is N=4. The composite data rate is the cho-
sen number N times 64 kbps. E.g., 32 x 64 kbps = 2.048 Mbps.
DataRateI RW 0-7 This attribute controls the size of the overhead channel. Valid input is 0-7. Default value is 0.
(!!Keep it as 0)
terminal RW Central
Remote Central – CO unit
Remote – CPE unit
Interface RW Hdlc Utopia – Data will be packaged in ATM cell format and send through the UTOPIA interface of
the processor
Hdlc – Data will be packaged in HDLC frame and send through the PCM Bus
Action WO Start
Deactivate
Start – Command the box to configure the DSL chip and start the handshaking process
Deactivate – Command the box to disconnect and deactivate the DSL link.