Operating Local Analog Loopback (LAL)—Serial Port Loop
139
Model 3086FR ATM IAD User Guide
13 • Diagnostics
– Npimage
– Key
– Initbun
– Im.conf
– Tftpupdt.rbt
– Tftpupdt.end
– Script.bat
2.
Connect the control (console) port of the unit to a PC.
3.
Connect the Ethernet port to the appropriate device where the upload package will be stored.
4.
On a Window 2000 or WinXP machine, open a Command Prompt and run the script. (The script will
connect to the default 192.168.200.10 IP address). If using Win9x, a TFTP client will be needed.
5.
The TFTP process takes about 90 seconds, the unit will reboot automatically when done.
Operating Local Analog Loopback (LAL)—Serial Port Loop
The Local Line Loopback (LAL) applies to serial port data traffic, it does not affect traffic from the Ethernet
port. The local Loop test checks the operation of the local Model 3086FR, and is performed separately on each
unit. Any data sent to the local Model 3086FR in this test mode will be echoed (returned) to the user device
(i.e, characters typed on the key-board of a terminal will appear on the terminal screen).
Figure 29. Local Line Loop
To perform a Local Analog Loopback test, follow these steps:
1.
Move the front panel toggle switch UP to
Local
.
2.
Verify that the data terminal equipment is operating properly and can be used for a test.
3.
Perform a V.52 BER (bit error rate) test as described in secton “BIT Error Rate (V.52) Diagnostics” If the
BER test equipment indicates no faults, but the data terminal indicates a fault, follow the manufacturer’s
checkout procedure for the data terminal. Also check the interface cable between the terminal and the
Model 3086FR.
Operating Remote Digital Loopback (RDL)—DSL Loop
The Remote Digital Loopback (RDL) test checks the performance of both the local and remote Model
3086FRs, as well as the communication link between them. Any characters originating at the serial port and
sent to the remote Model 3086FR in the test mode will be returned to the originating device (i.e, characters
Summary of Contents for ipRocketLink 3086FR
