4.4.3 Interface Power Option
The Model 2070 can also be powered by the appropriate V.24, V.35 or
X.21 interface pin (See Appendix D). Voltage supplied should be +5V
(±5%) regulated DC, 300mA min. When powered by the interface,
the power transformer must not be connected.
4.4.4 DC Power Supply
The 36-60 VDC DC to DC adapter is supplied with the DC version of
the Model 2070. The black and red leads plug into a DC source
(nominal 48VDC) and the barrel power connector plugs into the barrel
power supply jack on the 2070
.
20
Notice!
If any version of the Model 2070 is to be powered by
the host interface, please refer to the host’s installation manual
and ensure that the combined power required by the host, and
the total of all the additional peripherals, installed both
externally and internally, does not exceed the power
specifications of the host apparatus
4.3 DTE (TERMINAL) CONNECTION
The V.24, V.35 or X.21 side of the Model 2070 Series units are
wired as a DCE and support a wide range of applications. You may
purchase adapter cables from Patton Electronics. If you would like to
construct your own interface cable, refer to the pinout diagrams in
Appendix D or contact Patton Electronics Technical Support: (301)
975-1007; [email protected]; or http://www.patton.com for
specific interface pin assignments.
4.4 POWER CONNECTION
The 120VAC U.S. wall transformer version su5V regulated
DC up to 300mA. The variable 110/230VAC “international” version
su5V regulated DC up to 2A. Either of these transformers
connect to the Model 2070 by means of a cannon jack on the rear
panel. The Model 2070 is powered-up as soon as it is plugged into an
AC outlet–there is no power switch.
4.4.1 120 VAC Power (US)
The 100-132 VAC adapter supplied with the U.S. version of the
Model 2070 is a wall mount type and may be plugged into any
approved 120 VAC wall plug.
4.4.2 230 VAC Power (IEC)
The variable 100-240 VAC adapter supplied with the “international”
version of the Model 2070 is equipped with an IEC-320 shrouded male
connector. This connects with one of several available country-specific
power cords (see the ordering information in Appendix C). You may
purchase these power cords from Patton Electronics, or from a vendor
of your choice.
(continued)
19
Notice!
Any line or terminal cable connected to the Model
2070 Series must be shielded cable, and the outer shield must
be 360 degree bonded–at both ends–to a metal or metalized
backshell.
To Power
Supply Jack
To -48VDC
Source
-Vin
+Vin
SWITCHING POWER SUPPL
Y
MODEL
: SYD1
106-0505
INPUT
: 36-60V 0.2A
MAX
OUTPUT
: +5V 1.0A
OUTPUT
POWER : 5W MAX
S/N
: G01234567890
MADE IN CHINA
BY
SUNNY
Black lead (-V)
Red lead (+V)
Barrel power connector
Summary of Contents for 2070 Series
Page 16: ......
