Pattfield Ergo Tools PE-3050, User Manual

Page: 150 / 155

EN 150
Operation
Warning! Always wear eye protec-
tion with side shields. Failure to do
so could result in objects being thrown into
your eyes and other possible serious inju-
ries.
Warning! This equipment incorpo-
rates parts, that tend to produce
arcs or sparks. Do not use in explosive at-
mosphere.
Warning!
Never exceed the pres-
sure rating of the attached tool as
recommended by the manufacturer. When
using the compressor as an inflation de-
vice, always follow the maximum inflation
guidelines stated by the manufacturer of
the item being inflated.
Start up
- Ensure On/Off switch
1
is pushed in to posi-
tion O (OFF).
- Close pressure regulator
6
clockwise.
- Connect compressor to a suitable outlet
(see technical data). Use a residual current
device (RCD) protected outlet.
- Connect the compressed-air hose and a
suitable tool following section “Draw output
pressure” on previous page and tool manual
(e.g. some tools need to be connected to the
hose after power up.)
- Pull out the On/Off switch 1 to position 1 (ON).
- Set the pressure regulator
6
to the minimum
pressure suitable for your tool or inflatable
item.
NOTE: When the appliance is on, the air com-
pressor will automatically run, as long as the
tank air pressure is below the preset pressure
limit. It will shut off when the max pressure is
reached.
Start up after overload cut-off
- Ensure On/Off switch
1
is pushed in to po-
sition O (OFF) and let the compressor cool
down entirely.
- Press the overload switch 15 .
- Proceed with a regular start up.
Shut off
- Push down the On/Off switch 1 to position
O (OFF).
- Unplug the compressor.
- Release output pressure by fully rotating the
pressure regulator 6 counterclockwise.
- Release tank pressure by pulling the ring
of the safety valve 18 until no more air es-
capes.
- Drain the tank.
Using the supplied tools
- When using the tools always follow the
safety instructions given in this manual.
- First connect the orange air hose either to
the set pressure air outlet 5 or to the tank
pressure air outlet
7
.
Washing gun with steel cup
- Screw the steel cup anticlockwise and re-
move it.
- Fill the steel cup with a suitable liquid of
your choice. Do not fill it completely up to
the top.
- Reattach the steel cup to its mount by
turning it clockwise.
- Connect the washing gun to the air hose. It
can be used now.
Air blow gun
- Connect the washing gun to the air hose.
- Attach the opening of the air blow gun to
the valve of a bicycle or car tire and make
sure that it is fixed properly by the clasp.
- You can also connect a needle or another
suitable attachment to the opening of the
air blow gun.
- The tool can be used now.
- The released pressure can be read from
the pressure gauge of the air blow gun.