EN
Translation of original owner’s manual
94
Guide bar
•
Reverse the bar occasionally to prevent partial wear.
•
The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise,
the bar rail is
worn. Such a bar needs to be corrected or replaced.
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
The table contains a list of all possible combinations between bar and chain, indicating those
which may be used on machine.
Pitch
Guide bar
Chain
Zoll
Code
Length
Inches/cm
Groove width
Inches/mm
Code
Number of
drive links
3/8”
Oregon
140SDEA041
14”/35 cm
0.050”/1.3 mm
Oregon
91P053X
53
3/8”
Oregon
160SDEA041
16”/40 cm
0.050”/1.3 mm
Oregon
91P057X
57
For replacement use only above bars and chains. If you use non
-
approved combinations it may
cause serious personal injury and damage to the machine.
9. Maintenance of Saw Chain and Guide Bar
WARNING
Summary of Contents for BP 41
Page 2: ......
