EN
Translation of original owner’s manual
82
9.
Hold
the chain saw securely on the ground and
repeat pull out
the cord until the engine start.
10.
Pull up the front handle guard toward the front handle to
release brake. Then, allow the engine to warm up with
the
trigger pulled slightly.
Before you start the engine, make sure the saw chain is not
contacting anything. Make sure the chain brake always is
activated before each starting.
Hot starting:
To hot start the engine immediately after it has stopped, follow
steps 1
– 2 – 3 –
4
–
6
–
9
–
10 of the above procedure, making
sure the primer bulb is activated 2
-
3 times only.
■
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed and
see if chain oil is scattered off as shown in the figure.
Chain oil
The chain oil flow can be changed by inserting a screwdriver in
the hole on bottom of the clutch side. Adjust according to your
work conditions.
Chain oil flow adjusting shaft
Turn the shaft clockwise
–
Flow rich
Turn the shaft counter
-
clockwise
–
Flow lean
The oil tank should become nearly
empty by the time fuel is used up. Be sure to refill the oil tank
every time when refueling the saw.
6. Operation
WARNING
IMPORTANT
Summary of Contents for BP 41
Page 2: ......
