Paton ProTIG-200, User Manual

Page: 41 / 51

PATON ProTIG DC TIG/MMA
- 40 -
end current over the time Tc, and will remain at this level until the button is pressed. After
releasing the button, the arc will extinct and postblowing with the shielding gas will occur.
The welder chooses button modes personally depending on the welding
conditions.
Typical cyclogram of operation of 2-stroke mode operation with "pulse" (TIG D С/2T+ pulse)
function
Typical cyclogram of operation of 4-stroke mode operation with "pulse" (TIG D С/4T+pulse)
function
Example of using pulsed mode:
Switch on the device and choose the mode of TIG DC welding. Set up basic parameters as
follows:
1. "Button mode"
– mode of button on the torch – 2 Т .
2. "Preflow"- time before blowing – 2 s.
3. "Start current" – 30 А .