How To...
2. Touch
.
3. Touch Showfile on the left hand side of the screen.
4. Select “Save to USB”.
5. Press Exit
to return to programming once the Save to USB icon
changes from red to grey again. It's then safe to remove you thumb drive.
NOTE
You will not see Save To or Open From USB options until a USB thumb
drive is inserted into your console.
How to Strike/Unstrike an Arc Light or Reset
a Moving Light
Arc fixtures require special steps to start, or ‘strike’, the ballast to turn the light
on. Most moving lights have a similar setting that will reset, or recalibrate, the
fixture’s pan, tilt and other attributes.
1.
that requires the ballast strike, or requires a reset. Several
lights may be selected at the same time, but remember that the fixture
attributes displayed by Cognito are determined by the first light selected.
2. From the bottom of the screen, touch the Control icon
.
3. Touch the Intensity icon
to access the Intensity tool bar.
4. Touch the Wheels icon
.
5. Use the Red Wheel
to set the Control option to “Lamp On” or “Lamp
Off”, to strike or unstrike the arc light, or to “Reset” to force a moving light
to run its recalibration routine.
6. After seven seconds, change the option back to “Idle” or simply Release
the lights.
How to Shut Down the Console
1. Press the Power Button
near the top of the console.
2. Press the Power Off icon.
15