Control Identification
© 1996-2001 by PAT GmbH
∙
D-76275 Ettlingen
∙
Hertzstr. 32 - 34
∙
++49 (0) 7243 709-0
∙
FAX ++49 (0) 7243 709-141
11
19_1272E.DOC / 2001-04-02 / Rev. C / ko.
(7)
Button "Reeving"
The button
Reeving
(7) is actuated if a new reeving is to be en-
tered.
The button
Reeving
lights upon actuation to indicate that the func-
tion
"Enter the reeving"
has been activated.
At the same time, the
A2B switch pilot lamp
(2) and the
overload
pilot lamp
(4) light up and the crane movements are interrupted.
WARNING
The correct setting is of utmost importance for the proper function of the system and the
crane.
·
The procedure on how to enter the reeving is described in chapter 4.2.
(8)
Button "Taring"
The button
"TARE"
(8) serves to output the net load on the
load
display
(see #F, chapter 3.4). The net load is the real load minus
tackle and hook block. The button
"TARE"
has to be actuated
be-
fore
starting the lifting procedure.
Upon actuation of the button
"TARE"
(8) the load display is set to
zero (tared) and the
tare symbol
(see #G, chapter 3.4) starts to
blink. When the load is lifted, the load display shows the net load
(payload).
As soon as the working radius (by angle or radius modification) is
modified, the display shows again the real load and the taring
function is completed.
NOTE
The real load contains hook block, lifting rope and all tackle. The net load is the present
load on the hook without tackle. Display errors can be caused by environmental influences
such as wind acting on boom or load.