PAGE 46
GB
g.
Replace the locking washer and
the clamping screw by pressing
on the locking device and
tightening firmly
counterclockwise
.
12. Replacement of a saw blade
a.
Follow the steps described for mounting the blade up until step e.
b.
Remove the old saw blade and replace it with the new one, then release
the base plate.
c.
Follow the steps described for mounting the blade from step g.
13. Installation / adjustment of the parallel stop
a.
Loosen the
thumbscrew on the base plate and insert the parallel stopper
in its location.
b.
Set the desired cutting width using the scale on the stopper parallel to the far left of the base plate and
tighten the wing screw.
14. Adjusting the cutting depth
NOTE:
We recommend choosing a cutting depth about 3 mm larger than the thickness of the material. This way, you will get a
clean cut.
Unclip the locking screw and adjust the desired cutting depth.
15. Use of the portable circular saw
a.
Switch on the device as described in „Switching on and off“ and place the front of the base plate on the
material.
b.
Unlock the protective casing using the switch
and the parallel stopper or follow the line drawn.
c.
Keep both hands on the handle and saw with moderate pressure.
16. Maintenance
After each use, the saw must be unplugged and cleaned with a brush or compressed air. Never use any liquid
(solvent, water...).
17
