Passap E 8000, Operating Manual

Page: 148 / 266

Error messages
Error messages can appear during knitting as well as during programming . There is
always a text and a four digit number. In many cases the text will be self
explanatory. However you will find below a more explicit explanation of most of the
error numbers that can appear.
Generally every error message has to be aknowledged by pressing ENT.
Should a number appear which is not in the following list and which has no text,
then first unplug and plug in again the plug at the back of the operating unit and the
mains plug . If the same error message still appears, contact the nearest service
center and indicate which number has appeared.
Unravel l i ng rows
1 46
There are error messages where
"UNRAVEL 1 ROW' or "UNRAVEL 2 ROWS"
will appear after having acknowledged them by pressing
ENT.
N ote : release the fabric tacke dorn while unravelling
After having unravelled the indicated number of rows,
you will have to set the row counter back to the row
where you start knitting again.
Press the key
RWS
type the number of the row, where you want to go on
knitt i ng .
Note: you can only enter a even number.
That means after unravelling rows you can start to knit
again only when the carriage is at the right edge of the
kn i tting .
You can enter also a row number which is higher than the
position of your row counter at the moment. This can be
useful, if you want to skip part of a pattern, or if you want
to start knitting in the middle of a pattern.
After pressing ENT the indications for the two rows with
lock setting SX/SX will appear.