Passap E 8000, Operating Manual

Page: 27 / 266

The motor
KNITs
EJ
RWS EDG
EJ
G
GO
B
STOP
GO
STOP
�
EJ
PROG
s
PROG
F
E1 B EJ � �
B EJ E1 EJ
ENT>
B
EJE]
000
G
ENT
The motor is controlled by the three grey keys in the
above illustration. The functions of the keys are as
follows:
GO/STOP key.
This key is used to start and stop the motor. As soon as
you have pressed this key, the cam box begins to move
back and forth between the programmed edges as well
as, whenever the program calls for it, into the color
changer.
Note: once you have switched on the power, you may
press the GO/STOP key as soon as the display
START POSITION
appears. The cam box then
automatically moves into the start position and stops.
(However, if the cam box is situated too far to the right when you
switch the machine on, it will move into the end stop of the color
changer. and must then be pushed slightly to the left by hand.)
If you press the GO/STOP key again before having
confirmed the START POSITION with ENT, the cam box
moves into the color changer and takes over the first
feeder. It then moves back and forth over the complete
width of the bed without going into the color changer
again.
Attention: if the color changer is not set in a way as to
bring the first feeder into the cam box, an error message
will appear and after having acknowledged it by pressing
ENT, you cannot knit without programme any more .
25