PASIAN SOFIA, User Manual

Page: 17 / 57

user manuel
It is recommended to fill the system to a pressure of 1.0 - 1.2 bar. In case of
installation in rooms where the temperature can drop below 0 ° C, it is necessary to
insert a special antifreeze system as the stove does not have an automatic antifreeze
system.
If the hardness of the water in your home is high (above 20 ° f), it is mandatory to
install a water softener and a filter upstream.
PROSPETTO RIASSUNTIVO
The indicative assembly diagrams of the “IDRO” systems are shown below. PASIAN
strongly recommends to ALWAYS position the circulation pump on the return of the
system and near the boiler, so that the pump itself pushes into the boiler and to
position, in the case of assembly with closed vessel, an automatic vent valve at the ''
outlet of the thermo stove delivery pipe (if the kit is not installed in the appliance).
ATTENTION:
IDRO (boilers and thermo stoves) are normally produced complete with circulator and expansion
tank (see table above).
In the installation it is recommended to make journeys as short as possible to connect
to the water system, taking care to insert a vent valve at each change of slope, in the
highest part of the slope itself.
For the floor system, necessarily interpose a mixing valve and / or an accumulation
boiler.
For optimal installation it is recommended to connect the boiler directly to the
manifold.
For any other need, contact technical assistance or the retailer.
Scarico fumi
Ø 80 mm
Attacchi acqua 1"
Prevalenza pompa 6 mt
Vaso espansione 8 lt
Presa d’aria Ø 60 mm
14