Partlow MRC 7000, Installation & Operation Manual

Page: 18 / 64

18
Configuration 3.1
After completing installation and wiring of the instrument the configuration (set up) procedures
must be performed to prepare the instrument for operation of the intended application. The
procedures include selecting specific parameters, entering data and possible jumper position-
ing. Once properly configured the instrument will retain the user selections in memory. This
procedure need not be repeated unless required by changes in the application.
Parameter selections and data entry are made via the front keypad. To ease configuration
and operation, user entered data has been divided into several sections referred to as modes.
Each mode contains a different type of data or may be used for specific operating functions.
For two pen instruments, some modes are common to both pens. These modes are as
follows:
MODE DISPLAY CODE FUNCTION DESCRIPTION
Off oFF Operation Limits and Alarms
are Off.
Chart may stop
rotating(selectable)
Operate oPEr Operation Limits and Alarms
are Active
Test tESt Service Tests Instrument
Operation
Calibration CAL Service Calibrates Instrument
Program Prog Configuration Configure Operating
Parameters
Alarm Set ASEt Configuration & Enter Alarm Settings
Operation
Enable Enab Configuration Mode security
system, can lock
out everything except
Off and operate
(See Appendix A-1,
page 50, for
hardware lockout
information).
Associated with each mode is a series of unique displays which are accessed via the front
keypad.
Prior to first time operation of the unit, the configuration procedures for the Program and
Alarm Set modes must be performed as applicable. Calibration and Test modes are not used
as part of the instrument configuration or operation. These are used for service and mainte-
nance functions and are discussed in Section 4.6 of this manual (page 43).
Operation
(oPEr)
Test
(tESt)
Program
(Prog) Alarm Set
(EASt)
Calibrate
(CAL)