21
Step 2B - For instruments with software revision r3.00 and above
Upon power up, a brief flash on all displays (upper and, if equipped, lower) will occur to show
the instrument is "alive". Then 7XXX will be displayed (X representing digits) then XXXX, then
XXXX, identifying the twelve digit model number as defined in the order matrix. Next, the
EPROM part number will be indicated P-XX. After the EPROM part number, the software
revision level will be displayed in the format rX.XX followed by P.dn (if Pen Action on Power
Up, PAPU, in Program Mode is set to 0, pens go to "home" position at power up). During this
display, the decimal point after the "P" will blink to show the mode is active. Upon successful
completion of this routine, oPEr or oFF will be displayed for about 3 seconds. The mode
displayed will be mode that the instrument was in when the power was turned off. During this
time the operator may select another mode (Alarm Set, Enable) or non-operational mode
(Test, Program, Cal).
Step 3
If any error messages are displayed, refer to Section 4.6 (page 43) for a definition of these
error messages and the required action.
Front Panel Operation
3.5
3.5.1 DIGITAL DISPLAY AND STATUS LED’S
The digital display provided for each pen has 4 digits and a decimal point. Each digit has
seven segments and is capable of producing numeric characters from 0-9 and certain alpha
characters. The digital display is used to provide indication of process variable as well as
displaying codes used for configuration and operation of the instrument.
ALRM1
Red
Rcdr - Lights when Alarm 1 is on.
Limit - Lights when Limit has been exceeded.
ALRM2
Red
Lights when Alarm 2 is on.
C
Red
Lights to indicate that the process value is in terms of
degrees C (Celsius).
F
Red
Lights to indicate that the process value is in terms of
degrees F (Fahrenheit).
U
Red
Lights to indicate that the process value is in terms of
Engineering units.
-
Red
Lights to indicate a negative displayed value.
SP
Green
Indicates that the value displayed is the setpoint
(Limits only)
Refer to Figure 1-2 (page 6) for the display features.
Summary of Contents for MRC 7000
