Correction to the chapters:
z
“Welding with flux-cored wire” chapter under
the section “Inserting the flux-cored wire”
The torch nozzle
37
must be rotated in a clockwise
direction during assembly and disassembly and not, as
described in the user instructions, in an anti-clockwise
direction.
z
“Welding with flux-cored wire” chapter under
the section “Fit the gas cylinder” and under
the section Adaptation of device to flux-cored
wire welding with inert gas”
Before you connect the gas cylinder
29
to the pressure
regulator
14
make sure that the regulator of the pressure
regulator is set to the “OFF” position. To do this rotate
the regulator of the pressure regulator in a clockwise
direction and not, as described in the user instructions,
in an anti-clockwise direction.
To increase the gas flow, rotate the regulator of the
pressure regulator in an anti-clockwise direction towards
the “ON” position and not, as described in the user
instructions, in a clockwise direction. The “ON” and
“OFF” positions are shown correctly on the regulator of
the pressure regulator.
GB
IE
Please note
332971_1907_Kompaktschweissgeraet_PSGS_120_A1_Einleger_LB8.indd 4
332971_1907_Kompaktschweissgeraet_PSGS_120_A1_Einleger_LB8.indd 4
25.03.20 16:20
25.03.20 16:20
