48
GB/IE
with the “-” (see Figure U) and rotate
in a clockwise direct
ion to fix it in
place.
V
12
14
13
The gas flow can now be adjusted
using the pressure regulator
14
(see
Figure V). Rotating the regulator on
the pressure regulator in a clockwise
direction will increase the gas flow.
If you would like to use inert gas
from an external source (e.g. 20 l
gas cylinder), then you will need
a separate pressure regulator (not
included with the delivery). Connect
the external inert gas source with the
insert gas inlet tubing
13
of the weld-
ing device. To do this an adapter
may be required (not included with
delivery). Also observe the notes for
your separate pressure regulator. You
can use the following formula as a
guideline for adjusting the gas flow:
Flux-cored wire diameter in mm x 10
= gas flow in l/min
For example, using 0.8 mm wire,
will give a value of approx. 8 l/min.
z
Adaptation of device to
flux-cored welding wire
without inert gas
If you are using solid wire with
integrated inert gas, then you do not
have to have an external inert gas
supply.
First connect the plug
9
with the con-
nector marked with the “-” and rotate
it in a clockwise direction to fix it in
place. If you are in any doubt, then
please contact a professional.
Then connect the earth cable
6
with the corresponding connector,
marked with the “+” and rotate
in a clockwise direction to fix it in
place.
z
Inserting the flux-cored
wire
Unlock and open the cover of
the wire feed unit
1
, by pushing
the release knobs
39
upwards
(see Figure T).
Unlock the roller unit by turning
the roller mount
34
clockwise
(see Figure G).
Pull the roller mount
34
off the shaft
(see Figure G).
Note:
Make sure that the end of the
wire does not come loose and cause the
roll to roll out on its own. The end of the
wire may not be released until during
assembly.
Completely unpack the flux-cored
wire welding spool
17
, so that it can
unrolled without difficulty. Do not
release the wire end yet.
Place the wire reel on the shaft.
Make sure that the roll unwinds on
the side of the
35
wire feed guide
(see Figures H, N).
Welding with flux-cored wire
