Parkside PHDP 180 C2, Translation Of The Original Instructions

Page: 39 / 338

GB MT
39
4.
Clean the device with a soft brush or a
slightly damp cloth.
5. Occasionally clean the filter insert un-
der running water.
Cleaning the 3-in-1 nozzle
In rare cases, the 3-in-1 nozzle may be-
come clogged by foreign bodies.
1. Remove the 3-in-1 nozzle (23).
2.
Adjust the 3-in-1 nozzle so that the
nozzle to be cleaned and the connec-
tion are in a straight line.
3.
Remove the foreign body from the front
using the nozzle cleaning needle (6).
4. Rinse the 3-in-1 nozzle with water from
the front to remove the foreign body.
Cleaning the filter insert in the wa-
ter connection
1. Remove the quick connector for the
garden hose (29) from the water con-
nection (28).
2.
Remove the filter insert (30) from the
water connection.
3.
Clean the filter insert under running wa-
ter.
4. Fit the filter insert and quick connector
in the opposite order.
Replacing the batteries
Replace the batteries if the LC display (15)
is not displaying anything.
Power tools required
• Phillips screwdriver (not included)
Replacing the batteries
1. Remove the screw from the battery
compartment cover (16).
2.
Remove the cover of the battery com-
partment.
3.
Replace the batteries (35) in the bat-
tery compartment with new batteries.
Pay attention to the correct polarity
when inserting the batteries in the bat-
tery compartment.
4.
Press the switch lever (17) on the trig-
ger gun (1).
The LC display shows the selected pres-
sure. If the LC display is not displaying
anything, check whether the batteries
are inserted correctly.
5.
Insert the cover of the battery compart-
ment.
6. Fasten the cover of the battery com-
partment using the screw.
Maintenance
The device is maintenance free.
Storage
Information on storage
Always store the device and accessories:
• clean
•
dry
•
protected against dust
•
protected against frost
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and ac-
cessories will be destroyed by frost if they
are not completely emptied of water.
1. Completely empty the water from the
device.
• Disconnect the device from the wa-
ter supply.
• Turn on the pressure washer with the
On/Off switch (32) for a maximum
of 1 minute.
• Press the switch lever (17) on the
trigger gun (1) until there is no more
water coming out of the trigger gun
(1) or the attachments.
• Turn off the device.
2.
Completely empty the water from the
accessories.
3.
Store all attachments upright in the
holders with the connection facing
downwards.