Parkside PDBS 1800 A1, Translation Of The Original Instructions

Page: 16 / 84

PDBS 1800 A1
GB
│
CY
│ 13 ■
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed-air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the tool . Avoid
all skin contact with these substances . If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis . If dust is
produced or swirled up during maintenance,
it can be inhaled .
NOTE
► To ensure correct functioning and long-term
durability of the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning .
■ Check the speed and vibration levels after each
use .
■ Check the idle speed regularly and after any
maintenance is performed:
Use a rev counter and perform the measure-
ment without any clamped tools . At a residual
pressure of 6 .8 bar, the idle speed may not be
exceeded under any circumstances .
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired .
■ Use only the genuine replacement parts
recommended by the manufacturer, otherwise
you could put users at risk . In doubt, contact the
Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
Troubleshooting
Fault Possible
cause Remedy
Speed too
slow, air
escapes from
the outlet . Motor parts
jamming due
to dirt . Check the
pressure
supply filter
for contamina-
tion .
Pressure
supply too
low . Check the
pressure sup-
ply filter for
contamination .
Lubricate the
tool as de-
scribed in the
instructions .
If necessary,
repeat the
steps outlined
above .
Tool does
not move;
compressed
air escapes
completely
through the
outlet . Motor is
jammed due
to material
build-up . Lubricate the
tool as de-
scribed in the
instructions .