Parkside PDBS 1800 A1, Translation Of The Original Instructions

Page: 11 / 84

PDBS 1800 A1 ■ 8 │
GB
│
CY
■ Fingers might be crushed in nut wrenches with
an open pan head .
■ Keep your hands away from the rotating collet
chuck and the rotating drill .
■ Do not use the tool in confined spaces and en-
sure that your hands are not crushed between
the machine and the work piece, especially
when removing screws .
■ Safety goggles must be worn . The wearing of
protective gloves and safety clothing is recom-
mended .
■ Use personal protective equipment . Always wear
eye protection . Wearing personal protective
equipment such as protective gloves, non-slip
safety shoes or hearing protection, depending on
the type and use of the tool reduces the risk of
personal injuries and it is recommended .
■ The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed-air tool . Ac-
cessories which rotate faster than the maximum
permissible rate can break and throw pieces
into the air .
■ Wear a safety helmet for overhead work .
■ The tool will run on after the compressed-air
tool has been switched off .
■ Ensure that no hazard is caused by sparks cre-
ated during use . Explosive or flammable dusts
can be generated when processing certain
materials . There is a risk of explosion or fire .
Hazards caused by repetitive move-
ments
■ Users of an automatic screwdriver may experi-
ence unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts while
working with the tools .
■ Assume a comfortable position when working
with this machine, pay attention to safe footing
and avoid unfavourable positions or such that
make it difficult to keep your balance . During
work over longer periods, the operator should
change posture to avoid discomfort and fatigue .
■ If the operator notices symptoms such as
persistent discomfort, throbbing, pain, tingling,
burning or stiffness, these warning indications
should not be ignored . The operator should
consult a qualified medical doctor .
Hazards caused by accessories
■ Disconnect the machine from the energy supply
before changing the machine tool or accessory .
■ Do not touch fittings or accessories during
the striking process because this can increase
the risk of cuts, burns or injuries caused by
vibrations .
■ Avoid direct contact with the accessory tool
during and after use because it may be hot or
have sharp edges .
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of machines for screw connections; do not
use any other types or sizes of accessories or
consumable materials .
■ Use only impact fittings that are in good work-
ing order because any defects in the handles
and accessories can cause these to break and
be ejected when used with impact wrenches .
■ The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed-air tool . Ac-
cessories which rotate faster than the maximum
permissible rate can break and throw pieces
into the air .