Parkside 353549 2010, Translation Of The Original Instructions

Page: 16 / 185

PDFW 120 A2 ■ 12
│
GB
│
IE
Adjusting the tool rests
♦ Adjust the workpiece rests with the aid of
the knurled screws . Ensure that the space
between the grinding or the buffing disc
and the tool rest is as low as possible.
Ensure that the workpiece rests do not come
into contact with the grinding or the buffing
discs .
♦ Adjust the distance repeatedly as the
grinding or buffing disc wears down.
Fitting the spark deflectors
♦ Fit the spark deflectors with the aid of the
fixing bolts for the spark deflectors , nuts,
washers and spring washers to the top of the
device (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 7 mm
open end wrench. Tighten the fixing bolts for
the spark deflector using a Phillips screw-
driver.
♦ Fit the spark deflectors so that the distance
between the grinding or buffing disc and
the spark deflector is as small as possible.
The gap should not be greater than 2 mm.
Ensure that the spark deflectors do not come
into contact with the grinding or the buffing
discs .
♦ Adjust the distance repeatedly as the
grinding or buffing disc wears down.
Fitting the eye shields
♦ Attach the eye shields to the fixtures provided
on the spark deflectors using the mounting
screws for the eye shields , nuts, washers and
spring washers (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 8 mm
open end wrench. Tighten the fixing bolts for
the eye shields using a Phillips screwdriver.
Working procedures
Ensure that the appliance is always stable
and secure. For extra safety, you can secure
the appliance in a suitable location. There are
4 drill holes in the housing foot that can
be used for attachment to a secure and level
surface. Feed a suitable fixing material that
is appropriate for the surface (not supplied)
through the 4 drill holes . Fix the appliance
to the surface using the fixing material.
Ensure that the grinding and buffing
discs are not blocked.
Ensure that the eye shields , spark deflec-
tors
and tool rests are properly fitted
and adjusted!
A light grinding pressure is sufficient
Work using a light grinding pressure – a constant
and correct speed will ensure the best grinding
performance.
Grinding
Bear in mind that the workpiece heats up during
grinding. Therefore, cool the workpiece in a water
bath. Dry it thoroughly before you resume working.
Operation
Switching on and off
■ Direction of rotation of the tool!
NOTE
► Before first use, allow the grinding and
buffing discs to run without a load at top
speed for about 5 minutes. When doing so,
stay out of the hazard area in front of and
next to the openings in the grinding or the
buffing disc .
WARNING! RISK OF INJURY!
► Ensure the lowest-possible distance (gap)
between the grinding or the buffing
disc and the tool rest .
► If the appliance suddenly brakes completely
or jams, it must be switched off immediately.
♦ Set the eye shields so that they provide the
greatest possible protection.