1375 Hird Ave., Cleveland, OH 44107 • Phone (216) 521-8567 • Fax Local 521-9476 / USA & Canada (800) 344-9191
E-Mail: [email protected] •
Website: www.martindaleco.com
MODEL M-12 AIR GRINDER
INSTRUCTIONS
AIR SUPPLY REQUIREMENTS
1.
Supply tool with 90 psig (6.2 bar) of clean, dry air. Higher pressure drasti-
cally reduces tool life.
2.
Connect tool to air line using pipe, hose and fitting sizes shown in the dia-
gram on page 12.
3.
Do not install a quick coupler directly into the grinder throttle handle.
4.
Minimum compressor requirement: 3hp (2238 w), 60 gal. air tank.
LUBRICATION
Use an air line lubricator with SAE #10 oil, adjusted to two drops per
minute. If an air line lubricator cannot be used, add air motor oil to the inlet
once a day.
NOISE & VIBRATION DECLARATION
*
Sound pressure level 90 dB(A) in accordance with Pneurop 8N-1. For
sound power, add 10 dB(A).
Vibration value 3.0 m/s2, re. ISO 8662-1.
MAINTENANCE
1.
Disassemble and inspect air motor every three months if the tool is used
every day. Replace damaged or worn parts.
2.
High wear parts are underlined in the parts list.
*
These declared values were obtained by laboratory type testing in compliance with the stated standards
and are not adequate for use in risk assessments. Values measured in individual work places may be high-
er than the declared values. The actual exposure values and risk of harm experienced by an individual
use
r
are unique and depend upon the way the user works, the workpiece and the workstation design, as
well as upon the exposure time and the physical condition of the user. We, cannot be held liable for the
consequences of using the declared values, instead of values reflecting the actual exposure, in an indi-
vidual risk assessment in a work place situation over which we have no control.
! WARNING
SAFETY INSTRUCTIONS
To reduce risk of injury, everyone using, installing, repairing, maintaining, chang-
ing accessories on, or working near this tool must read and understand these
