Bulletin 76-00 B
14
Remote Communications Setup Instructions - Option 1
Steps
Setup Instructions
Display
Notes
1
Install the program (RS485 V300
Purger Interface V1.1.exe) on the
desired computer.
2
Run the 'RS485 V300 Purger
Interface V1.3.exe' Application.
Download the remote com interface at
www.ParkerRealSolutions.com
3
Connect the USB side of the USB/
RS485 cable to the computer.
4
Open the V300 Purger Controller
enclosure by unlatching the two
side latches.
5
Feed the other end of the cable
(RS845 side) through an unused
hole at the bottom of the V300
Purger Controller enclosure.
6
Plug in the RS845 (Cat5) connector
to the RJ45 Jack on the Display
Board affixed to the backside of the
Enclosure lid.
The adaptor's driver should be installed on the
laptop for the w port to be recognized.
7
If you are running the Remote
Communications on a Windows
Operating System, access ‘Device
Manager’ through ‘Control Panel’.
Under ‘Ports (COM & LPT)’,
double-click the COM port that
aligns with the RS-485 converter.
In order for the Remote Communications Interface
to run properly, the COM port settings on the
computer of choice, V300 Purger Controller, and
Purger Interface Application must match.
8
The following window will appear.
Select ‘Port Settings’ and ensure
that ‘Bits per second’ is 19200,
and ‘Parity’ is Even. Then click
‘Advanced’
Remote Communications Setup Instructions - Option 1
Summary of Contents for V300
Page 24: ...Bulletin 76 00 B 24 A A P P E N D I X...
Page 35: ...Bulletin 76 00 B 35...
