- 13 -
SECTION 5 – BASIC OPERATION
SWITCHING DISPLAYS
Each press of the [
DISP
] key switches the display as shown in the example below.
*1: The operation mode indication is not displayed when the ‘0: no operation mode selection by key
setting’ is selected at the operation mode selection
‘
C-02
’
in the function setup.
*2: If no operation is made while the operation mode is displayed, the display is automatically returned to
the instantaneous flow rate indication after approximately ten (10) seconds.
*3: When the [
ENT
] key is pressed for three (3) seconds or longer while the totalized flow rate is
displayed, the totalized flow rate is reset.
*4: The multi-setting flow rate is displayed only when the multi-setting (1 to 3) is selected at flow rate
setup number selection
‘
C-04
’
in the function setup. For details on function setup method, refer to
‘SECTION 6 – APPLICATION OPERATION’.
*5: If no setting change is made while the multi-setting flow rate is displayed, the display will
automatically return to the instantaneous flow rate indication after approximately ten (10) seconds.
Instantaneous
flow rate
flow rate
Instantaneous
Instantaneous
flow rate
Set flow rate
Operation mode
Totalized flow rate
Valve drive output
(SP value)
Setting flow rate
Setting flow rate
No. (SP No.)
Totalized flow rate
Power ON
Multi-setting
flow rate indication *4, *5
output indication
Valve drive
flow rate indication *3
Totalized
indication *1, *2
Operation mode
flow rate indication
Instantaneous
Lights
Blinking
Any key is not pressed
for 10 seconds or
longer
Press [DISP] key (1 second or longer)
Press [DISP] key or any key is not
pressed for 10 seconds or longer.
Press [DISP] key (less than 1 second)
Press [DISP] key
(3 seconds or longer)
Press [V] key
Press [DISP] key
Press [DISP] key
Summary of Contents for Porter MPC Series
Page 14: ...12 WIRING TYPICAL WIRING...
Page 30: ......
