2
www.parker.com/euro_pneumatic
2. Safety Instructions
2.1 General Safety Instructions for Standard
Operation (non-explosive area)
Introduction
Prior to operating the motor, make sure to carefully
read this operating instruction booklet (short OP).
Please pay attention to the additional safety
instructions in the individual chapters of this OP.
The air motor or its load may have hot surfaces, during
and after operation.
Assembly / installation, connection, operation as well as
maintenance and repair work may only be performed by
Parker or qualified persons / technical experts
Injury and damage to property may occur due to
inaccurate installation and operation or
non-designated use of motor.
Dealing with Compressed Air
• Always wear safety goggles.
• Do not move into the stream of compressed air.
• Do not use the motor with other gases or liquids.
• Do not operate the motor at higher pressure than
specified.
Intended Use
This air motor is mainly used to generate a rotating
motion in industrial equipment.
Basically, the air motor is approved for the use in the food
industry. For the particular application the operator must
comply with the valid legal requirements.
The motors’ technical data, as well all
pertinent conditions for its use, can be found in this OP.
Deviations from these requirements are not allowed!
2.2 Owner Obligation
The owner is obliged to only let persons operate the equipment, who:
• are familiar with basic work environment safety rules and accident-
preventing regulations. Also, those persons must have been
instructed in the correct use of the equipment.
• have read and understood all safety and warning notifications in
the operating instruction booklet, as well as all other documentation
pertaining to this equipment.
• check and confirm at regular intervals, that a safety oriented operation
is guaranteed.
Only qualified and authorised personnel are allowed to operate,
maintain and repair this equipment. A malfunction, which impairs
operator safety, must be immediately removed.
2.3 Operator Obligation
Personnel, who are engaged in the operation of the equipment, must
always be committed to:
• observe the basic safety and accident preventing regulations.
• read and observe the safety and warning notifications of this
operating instruction booklet.
2.4 Warranty and Liability
Unless otherwise specified, our “General Sales and Delivery Conditions”
apply. Warranty and liability claims in regards to persons or equipment
damage are invalid if one or several of the following causes apply:
• Use of the equipment in a non-designated application.
• Improper installation, operation, service or maintenance of the
machine.
• Operation of the machine with either defective or removed safety and
protection devices.
• Non-observance of the requirements stated in the operating
instruction booklet, in regards to transportation, storage, mounting,
installation, operation, maintenance and service of the equipment.
• Structural change or adjustment on the equipment to a
non-designated use.
• Inadequate supervision of wear parts.
• Improper repair, inspection or maintenance.
• Catastrophic cases because of a war, acts of god or other reasons
which are beyond our control.
2.5 Additional Safety Instructions for Use of Motor
in Explosive Area
Explosive gas- or dust atmospheres may cause
grave or fatal injury when coming in contact with hot
or movable parts in the air motor.
Assembly / installation, connection, operation as well as
maintenance and repair work may only be performed by
Parker or qualified persons / technical experts and if the
following items are observed:
• read OP
• all warning and alert messages attached to the air motor
• all other or the operation pertinent documentation, such
as project documents, operating instructions and
control diagrams
• all machine specific regulations and requirements
• the most current and valid national/regional regulations
(explosion protection, safety, accident prevention)
Intended Use
This air motor is used to generate a rotating motion in
industrial equipment and it needs to be operated in
accordance with the instructions of the technical
documentation, while observing the information
inscribed on the tag. It corresponds to all valid standards
and regulations and fulfills the requirements per guideline
94/9/EC (ATEX).
It is not permissible to use this air motor as a
braking motor.
The air motor may not be used underground by mines
or any of their distribution stations, where pit gas and/
or other flammable dusts occur. It may be used in areas
where occasionally explosive atmospheres occur, which
may be a combination of air and gas, or steam and fog of
a flammable fluid or dust/air mixture (Zone 1 and Zone 21).
Air motors without an engraved -Symbol are not
designed for the use in Ex-areas (see chapter 4.4)
3. Delivery Capacity
Check that the shipment is complete and that there have been no
damages in transit.
Quantity
Name
1
Operating Instruction Booklet
1
Pneumatic Air Motor
