Parker MDC Series, User Manual

Page: 11 / 57

Parker Hannifin Manufacturing Srl user’s manual MDC
11
2.2 Identification
The converters of the MDC series are available in different models. The number that follows
the MDC abbreviation corresponds to the rated current of the converter in amperes.
Use the following table to specify the order code:
MDC 60 30 5 9 E 64 2
E A 70 52 8 11 S Hxx F4 M R D 65 4
82 60 14
100 19
24
Where :
MDC MotorNET DC
E Encoder
A Brake (n.a.)
60 Motor size (60, 70, 82, 100)
30 Motor Speed (3000, 5200, 6000 rpm)
5,8 Flange type (type 5 on size 60, 70, 82, 100; type 8 on size 60)
9…24 Shaft diameter
With keyway
S Without keyway
Standard shaft
Hxx Hollow shaft (xx = internal diameter – only for MDC70, 100 with resolver)
Resolver
F4 Encoder EnDat
M Increased inertia (n.a.)
R Safe torque off
D CANopen DS402 (n.a.)
E EtherCAT
64 IP level (65 IP level n.a.)
2 Power supply voltage: 230V
4 Power supply voltage: 400V
A label attached of the device contains all the essential information to correctly identify the
unit:
Serial number
Model
Nominal plate data
It is important to refer to this label before requesting any kind of technical information to
Parker Hannifin Manufacturing