Installing the Drive
3-9
650V AC Drive
LED Indications
The module has three LEDs providing diagnostic
information about the 650V host drive's ‘Health’,
‘Receive’ and ‘Transmit’ activity.
HEALTH = Green, Rx = Red, Tx =Red
LED Name
LED Duty
Drive State
HEALTH
SHORT FLASH
Re-configuration, or corrupted non-volatile
memory at power-up
EQUAL FLASH
Tripped
ON
Healthy
LONG FLASH
Braking
OFF
No drive power, or serious hardware fault
Rx
INTERMITTENT
Indicates activity on the ‘receive’ line carrying
data from the Master
Tx
INTERMITTENT
Indicates activity on the ‘transmit’ line carrying
data to the Master
Configure the Drive
Before the module can be used you must configure the drive to your system. Set-up the
parameters in the SERIAL menu as appropriate. Refer to Chapter 6: "Programming Your
Application" - SET::SERL Menu, parameters
S
SE01 to
S
SE08.
For Tag number information refer to the 650V Software Product Manual, available on the Parker
SSD Drives website: www.SSDdrives.com.
Note:
This Option can only be used on drives using software version 4.1 or higher.
Encoder Connections
The drive is
only
suitable for use with single-ended encoders.
Take special care wiring the encoder to the drive due to the low
level of the signals.
All wiring to the drive should be made in screened cable. Use
cable with an overall screen and a screen over each individual
pair. To ensure compliance with the EMC Directive the overall
cable screen should be connected to the drive chassis.
Recommended cable (pairs individually screened):
Belden equivalent 8777
SSD Drives Part Number CM052666
The drive will operate with 5-24V encoders. Provide the correct supply for the encoder. Do not
use the 10V or 24V supply from the drive.
The maximum input frequency of terminals 12 and 13 (ENCA and ENCB) is 100kHz.
12
13
ENC A
ENC B
A
B
+
-/0V
supply
ENCODER
Drive
chassis
DRIVE
Encoder
supply
-/0V
0V
1
Lefflersgatan 1, SE-754 50 Uppsala, SWEDEN
+46 (0)18-65 70 00
+46 (0)18-10 74 78 [email protected] www.regal.se
