EN
| User Manual
Technical product description
14
BSP-MT
1-8/D3
Technical product description
Summary drawing
Front view
Function description
The dryer dries the compressed air supplied by the compressor and makes it available for
industrial use.
The air is thereby dried alternately in one of the double-chamber of the hollow section vessel.
The dried air is subsequently purifi ed in the third chamber, whereby oil residue and other
contaminants are removed.
Before the compressed air is fed into the dryer, it fl ows through upstream fi lters where dust,
dirt, oil and water droplets are removed. Thus, the installed upstream fi lter is also used for
extending the service life of the drying agent.
The installed downstream fi lters clean the compressed air from drying agent abrasions, be-
fore it is fed into the compressed air system.
The two chambers of the hollow section vessel contain an extremely porous drying agent by
means of which humidity is removed from the compressed air and stored just as in a sponge.
The stored humidity is then removed again from the drying agent and re-introduced into the
ambient environment.
To this end, the two chambers alternate between different operating modes. Whilst in one
vessel, compressed air is de-humidifi ed (adsorption), in the other vessel the humid drying
Check valve plate
(RV1–RV2)
Compressed air inlet
Upstream fi lter
Condensate trap
Power connection
Muffl er
Dewpoint sensor
(optional)
Compressed air outlet
Downstream fi lter
Manual drain valve
Switchbox with Multi-
tronic control
Single-chamber vessel
Solenoid valves
Differential pres. gauge
(only KA-MT 6–8 )
Differential pres. gauge
(only BSP-MT 6–8 )
ON/OFF switch
Solenoid valves (Y1-Y4)
Double-chamber vessel
