Bulletin TI-FID1000J
Installation, Operation and Maintenance Manual
Technical Information
FID1000 and 2500 Gas Stations
1-800-343-4048
6
Figure 4 - Unscrew desiccant cap
Figure 5 - Insert new desiccant cartridge
Figure 6 - Press down firmly
on desiccant to seat o-ring
Figure 7 - Make sure the o-ring is
centered in the cap before replacing it
Power -
The Parker Balston FID Gas Station may be operated by a 120 VAC, 220 VAC, 230 VAC,
or 240 VAC, 50/60 Hz power supply.
Main supply voltage fluctuations must be within ±10% of
the nominal main supply voltage.
The generator is shipped with a tag at the power receptacle
which specifies the factory setting of the voltage selector. For optimal performance of the genera-
tor, the operator should set the voltage selector to match the local power supply. To change the
setting on the voltage selector, simply remove the selector/fuse drawer from the receptacle using a
small screwdriver, turn the selector so the desired voltage shows in the window, and reassemble.
To connect the generator to the power supply, simply plug the female end of the electrical cord
into the receptacle on the right side of the generator, and the opposite end into a three-pronged
earthed power receptacle.
Before plugging power cord into power receptacle, check the voltage selector setting. The
voltage setting must match the local power supply voltage. (Note: "NA" versions of the
generator are designed for 120 VAC operation only.)
Utilities
