Copyright © Parallax Inc.
ELEV-8 Quadcopter Kit (#80000)
Version 1.
1
Page 4 of 26
ELEV-8 QUADCOPTER ASSEMBLY INSTRUCTIONS
These instructions are for assembling the ELEV-8 quadcopter in its most standard configuration. Some steps are optional; we’ll explain those
along the way. The ELEV-8 quadcopter platform is designed for creative experimentation and adaptation; however, we recommend that you try
the standard configuration first, and then experiment at your own educated risk.
These instructions are available online as a full-color PDF; go to
www.parallax.com
and search “80000”.
Preparation
1.
Read the entire assembly instructions before beginning.
Assembly and testing takes about eight hours on average.
2.
If you are missing any components, email
[email protected] or call 888-512-1024 (inside
continental US) or 916-624-8333.
3.
Gather all of the additional items and tools required.
4.
Charge your LiPo batteries with their charger.
Additional Items Required
RC radio controller and receiver; 5-channel minimum required
for flight
LiPo Battery, 3000 to 4400 mAh 3-cell 30 C discharge rate
LiPo Battery Charger
Tools Required
Soldering iron, solder, and flux
Component vise
#1 Phillips screwdriver
1/4 inch wrench, box-end or socket
11/32 inch wrench or nut driver
Wire strippers/cutters (12-16 AWG)
Scissors
Needle-nose pliers
Ruler or measuring tape
Heat gun or blow dryer (for heat-shrink tubing)
Step 1: Motor Set Screws
Start by applying Blue Loctite to the motor set screws, to prevent them from coming loose during flight and causing equipment failure.
1.
Locate the Blue Loctite 242, the four motors, and the small Allen wrench in the ELEV-8 Hardware Kit.
2.
Refer to the drawing on the next page. Using the Allen wrench, carefully remove the Motor Set Screws (item 2) from each motor (item 1).
The screws may be very tight; be careful not to break your Allen wrench.
3.
For each motor, apply a small amount of Blue Loctite to the Set Screw threads and carefully reinstall the screws. Seat each screw firmly but
do not over-tighten. Allow the Blue Loctite to set for 10 minutes. It fully cures in 24 hours.
