Paradyne Hotwire 8779, User Manual

Page: 130 / 182

A. Configuration Options
A-34
May 2002 8700-A2-GB20-40
SNMP Traps Options
An SNMP trap can be automatically sent out through the EOC or the Management
port to the SNMP manager when the unit detects conditions set by the user. These
traps enable the SNMP manager to gauge the state of the network. Refer to
Appendix B, Standards Compliance for SNMP Traps , for details of SNMP traps
supported by the Hotwire Termination Unit.
To configure the unit for SNMP traps, use the SNMP Traps Options screen to:
„
Enable SNMP traps.
„
Set the number of SNMP managers that receive SNMP traps from the unit.
„
Enter an IP address and network destination for each SNMP manager
specified.
„
Select the type of SNMP traps to be sent from the unit.
To access the SNMP Traps Options screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Current Configuration
→
Management and Communication
→
SNMP Traps
main/config/management/trap
Slot: 4 Model: 87xx
SNMP TRAPS OPTIONS
SNMP Traps: Enable Number of Trap Managers: 9
NMS 1 IP Address: 135.014.040.001 Clear
NMS 2 IP Address: 135.014.003.027 Clear
NMS 3 IP Address: 135.014.001.008 Clear
NMS 4 IP Address: 135.014.002.024 Clear
NMS 5 IP Address: 204.128.146.035 Clear
NMS 6 IP Address: 135.014.003.028 Clear
NMS 7 IP Address: 135.014.001.009 Clear
NMS 8 IP Address: 135.014.002.025 Clear
NMS 9 IP Address: 204.128.146.036 Clear
General Traps: Both Enterprise Specific Traps: Disable
Link Traps: Both Link Traps Interfaces: All
-------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Save