Under the feed tray the output rollers are attached by a screw to the side. Unscrew by hand and
remove.
Remove the ties on the 2 bottom fold plates.
INSTALL OUTPUT TRAY
The PH-17 can be ordered with either a Knife folder to perform a cross fold, or a Stacker which neatly
stacks very small, folded pieces.
FOLLOW THE GUIDES BELOW FOR YOUR SETUP
IF YOU ARE INSTALLING THE PH-17 TO OPERATE BY ITSELF
Slide the output tray into machine just below the rubber rollers. The 2 slots on the end fit on a bar.
Lower it with the slots fitting on the bottom on the outer bar. Make sure the gears are aligned on the
right side.
Install the output wheels by placing the side of the T-shaped mount with the spring in the hole closest
to the rollers on the left side of the machine. Note that it has to go under the cross bar. Press it in so
Page
4
PaperFolder.com
