If a fold does not work as it should, check that the fold plates are properly installed and on the right
posts. THIS IS USUALLY THE PROBLEM IF THE FOLD IS NOT WORKING CORRECTLY OR THE PAPER JAMS. IF
THAT HAPPENS, TAKE THEM OUT AND REINSTALL THEM.
PAPER CREASERS
There is a paper creaser on the back of the PH17 which can be used when you want to perform a
cross fold. A crease makes the fold tighter.
To set the machine to make a crease, move the 2 lower side wheels under the creaser wheel, but not
under the creaser. it will place a crease in the middle of the paper to make a cross fold in half. Use
an Allen wrench to loosen the set screws so they can be moved, then retighten.
To stop creasing, move the wheels away from the creaser using an Allen wrench to loosen the set
screws. Put them directly under the wheels above as shown in the first image.
In this picture, the creaser is not set to crease the paper.
NO CREASE
SET TO CREASE
Page
10
PaperFolder.com
