g. The machine will stop after it folds the number you set. Remove them. It will start again
after the period you set expires.
h. Stop when you have the number of sets you want.
2. THE NUMBER OF SHEETS IN THE BATCH IS WRONG
The speed can be adjusted to make accurate sets. For example, if 10 sheets are programmed in
AutoBatch and 11 are pulled, the speed needs to be reduced. If only 9 sheets are pulled the speed
needs to be increased.
To enter the last form adjustment mode press and hold the
STOP button for 3 seconds, the screen will read “M_Count: ### MS”, note the number
shown, then press the BATCH button to adjust the speed (the speed will cycle up to 495 MS and then
go back to 005). To increase the speed, set to a higher number and to decrease the speed, set to a
lower number. To exit press the STOP button one time.
3. SETTING THE FOLDING SPEED
The folding speed is set at M3 from the factory.
This is the recommended speed for the machine.
If
you are using it with a knife folder or stacker, it must be used.
You can change it by holding down
the Stop and C buttons simultaneously, getting to Motor Speed, and push BATCH to increase or the
lower left button to decrease the speed. We DO NOT recommend that you change this.
SUCTION T
One of the readings on the control panel is Suction T. It should read 360ms. This is not a user
adjustable setting. Please make sure it reads 360ms.
SPECIFICATIONS
Fold Speed:
Varies with operator; up to 60 per minute over time.
Paper Size:
Minimum size: 4” W x 5.5” L Maximum: 11" W x 17" L
Paper Weight:
50—200 gsm Bond: 16 to 50# Text: 40 to 135#
For cross folds: 18 – 20# Bond required
Paper Surface:
No glossy or slippery paper
Feeder
Capacity:
300 sheets 18# bond
Dimensions:
240 x 550 x 464 mm (49" x 21.7" x 18.3")
Machine Weight:
48 Kg (106 lbs.)
Page
12
PaperFolder.com
