BA_PH_245-100-300_EN_06-22.docx
50
16.3
Safety Rulers for the Milling Fence
Figure 47: Safety ruler set
The optional safety rulers serve as a continuous guide between the two fence
plates. The set consists of:
•
2 safety rulers 260 x 6 mm
•
3 safety rulers 260 x 3 mm,
•
1 grooved board (multiplex) 260 x 150 x 12 mm,
incl. sliding blocks and Allen key
The article number can be found in section
16.4
Swivel-away Device for the Milling Fence
Figure 48: Swivel-away device
The practical swivel-away device (
W
) enables
all the milling fences available for the machine
to be lifted and lowered automatically. The
milling fence can be rotated 360° around the
column and also swivelled away to the front.
Before the fence can be swivelled away,
•
the two clamping levers (
3
) and (
6
) must
be removed (fence types 301 und 311),
•
the two quick-release levers (
3
) and (
6
)
must be loosened and the fixing screws
(
Figure 32) unscrewed (fence type 302),
•
the two fixing screws (
Figure 39) must
be completely unscrewed (fence type 320).
•
The lift-off command is given via button on the touchscreen control unit.
•
The detailed procedure for operating the device is described in the separately enclosed operating manual
BA_PH_UT300_EN
(refer to chapter “
Fence Positioning
” / section “
Swivel-away Devices
”).
•
Further information can be found in the sections on the respective milling fences in chapter
Article number see section
20.3 “Milling Fences”.
16.5
Turntable (360 degrees) for the Milling Fence
When ordering this option, the turntable (
1
) is already installed on the machine at the factory. The 360° rota-
tion range allows the milling fence to be flexibly rotated in all directions on the machine table.
Figure 49: Turntable with opening for clamping
•
At the front of the machine there is an
opening (
2
) with a clamping screw for fixing
the turntable.
•
Loosening and clamping is done with an
SW6 pin spanner.
Please note:
-
The turntable cannot be retrofitted.
-
The turntable cannot be used on machines
equipped with the fence type 320.
-
The turntable cannot be used on ma-
chines with optional table slide.
The article number can be found in the section
20.2 “Table Systems”.
W
1
2