BA_PH_690-200_EN_11-22.docx
75
Figure 94: Error message 5
Message:
Sawdust flap open!
Cause:
Sawdust flap is open or has opened by itself due to
wood chips.
Remedy:
Close sawdust flap.
Figure 95: Error message 6
Message:
Emergency stop button active!
Cause:
An emergency stop switch was actuated.
Remedy:
Check emergency stop on machine stand and control
panel and unlock if necessary.
Figure 96: Error message 7
Message:
Faulty load voltage! Check Fuse F4!
Cause:
•
Fuse F4 has tripped.
•
Axes jammed.
Remedy:
•
Reset fuse F4.
•
Remove blockade and check guides if necessary.
Figure 97: Error message 8
Message:
Motor protection tripped! Check Fuse F1 or F2.
Cause:
•
Motor protection switch F1 or F2 has tripped.
•
Main motor or scoring saw motor overloaded.
•
Power supply unit G1 defective.
Remedy:
•
Check fuses F1 / F2 and reset if necessary.
•
Check main resp. scoring saw motor.
•
Check power supply G1.
Figure 98: Error message 9
Message:
Motor protection "machine socket" tripped!
Cause:
•
Circuit breaker F6 has tripped.
•
Machine socket has been overloaded.
•
External connected device defective.
Remedy:
•
Check connected unit.
•
Check circuit breaker F6 and reset if necessary.
Figure 99: Error message 10
Message:
Error on Start/Brake device!
Cause:
•
Start / brake unit Q3 went into fault status.
•
Main motor overheated.
•
Circuit breaker F1 or F2 have tripped.
•
Unexpected fault in unit Q3.
Remedy:
•
Check fuses F1 / F2 and reset if necessary.
•
Allow main motor to cool down.
•
Check unit Q1.
Error is only cleared after restarting the machine!
