BA_PH_690-200_EN_11-22.docx
61
20.4.2
Super Gehrfix I Operation
Figure 70: Super Gehrfix I overview
20.4.3
Attach Cross-Cut Fence
The crosscut fence is mechanically connected to the Super Gehrfix I via the locating pin (
2
), which is located in
the slotted hole for the length compensation.
The procedure is very simple:
•
Loosen clamping lever (
1
) and push the locating bolt
(
2
) in the direction of the stop plate (
P
) as shown in
•
Now place the cross-cut fence (
L
) on the cross slide
so that the locating pin (
2
) can be inserted into the
receptacle (
X
) on the underside of the stop plate (
3
).
•
Then tighten the clamping lever (
1
) again.
Figure 71: Attach cross-cut fence
20.4.4
Set Length > 1885 mm
•
Loosen flip stop (
A
) with (
S1
), set to 1885 mm using magnifying glass and clamp with (
S1
).
•
Loosen flip stop (
B
) with (
S2
), move to the desired position and clamp with (
S2
).
20.4.5
Set Angle to 90 Degrees
For 90° cuts, the cross-cut fence (
L
) can be used in different positions:
•
Via the fixing points (
F
) on the left or right of the cross slide. To do this, simply release clamping lever
(
1
) lift off the cross-cut fence (
L
) completely and insert it into the desired fixing points (
F
).
•
Via the grid scale of the Super Gehrfix I (procedure see section
X
45°
135°
Saw blade thickness = 3.2 mm
L
1
Lever below
(hidden view)
4
3
F
(4 x)
5
X
45°
135°
Sägeblattdicke = 3,2 mm
L
1
Hebel unterhalb
(Ansicht verdeckt)
4
3
F
(4 x)
5
A
S1
S2
B
3
1
2
L
P
X
