BA_PH_245-10_EN_13-22.docx
44
16.3
Safety Rulers for the Milling Fence
Figure 38: Safety ruler set
The optional safety rulers serve as a continuous guide between the two fence
plates. The set consists of:
•
2 safety rulers 260 x 6 mm
•
3 safety rulers 260 x 3 mm,
•
1 grooved board (multiplex) 260 x 150 x 12 mm,
incl. sliding blocks and Allen key
The article number can be found in section
16.4
Swivel-Away Device for the Milling Fence
•
For detailed description, operation and function refer to section
•
Article number see section
„Milling Fences“.
16.5
Turntable (360 degrees) for the Milling Fence
When ordering this option, the turntable (
1
) is already installed on the machine at the factory. The 360° rota-
tion range allows the milling fence to be flexibly rotated in all directions on the machine table.
Figure 39: Turntable with opening for clamping
•
At the front of the machine there is an
opening (
2
) with a clamping screw for fixing
the turntable.
•
Loosening and clamping is done with an
SW6 pin spanner.
Please note:
-
The turntable cannot be retrofitted.
-
The turntable cannot be used on ma-
chines with optional table slide.
The article number can be found in the section
“Table Systems”
.
16.6
Extendable Frame Support
Figure 40: Clamping lever for extendable frame support
The table top with dimensions 1100 x 760 mm
can optionally be equipped with an extendable
frame support.
•
Toral length approx. 1375 mm
•
Extension depth approx. from the centre
of the milling spindle.
•
Guided in separate bearing blocks at the
side of the machine table.
The table is clamped by means of the two star
grips (
K
) which are located on the left and right
side of the table below the extension rods.
The article number, table extensions and other table systems can be found in section
Table Systems
“.
1
2
K
