BA_PH_245-10_EN_13-22.docx
31
10
Commissioning
Before commissioning, carefully read and observe this manual and the safety instructions in chapter
Before switching on, make sure that
•
the cutter is firmly and securely clamped,
•
the machine table and fence are clean and free of objects,
•
the guards are fitted in accordance with regulations,
•
the extraction system is connected and in good working order
•
and the direction of rotation is selected to suit the tool and work process.
10.1
Switching ON and OFF
The machine is switched on and off via the main switch (
1
) on
the right-hand side of the machine:
Switching ON
→
Turn the main switch to position “
I
”
Switching OFF
→
Turn the main switch to position “
”
If the milling spindle is started without a
cutter, all the milling arbor rings and the
clamping screw must be fitted and tight-
ened.
Figure 12: Main switch
After switching on the main switch (1), the speed set according to the V-belt position is indicated via the re-
spective signal lamp (
D
), see
Figure 13. The speed setting is made according to chapter
10.2
Rotational Direction Switch
The spindle direction of rotation is specified via the turn
switch (
R
) on the control panel:
Conventional milling
→
Turn switch (
R
) to the left
(anticlockwise rotation, switchover only at standstill).
Climb milling
→
Press in switch (
R
) and turn to the right
(clockwise rotation, switchover only at standstill).
Avoid climb milling, as this considerably
increases the risk of accidents!
Figure 13: Control panel
10.3
Switching the Spindle ON and OFF
•
To start the spindle, the main switch (1) must be turned on (position “
I
”).
•
Set the desired speed according to chapter
•
Switching ON:
Press “
I
”
on the switch (
F
)
→
The milling cutter is set in rotation with the preselected speed and direction of rotation.
Do not start working until the machine has reached full speed (after approx. 10 s).
•
Switching OFF:
Press “
”
on the switch (
F
)
→
The milling cutter is switched off and brought to standstill (braking time < 10 s).
1
4
L
F
R
D
