© Panduit Corp. 2022
FS132D
6
Rev 05
Step 5:
Strip the buffer in 1/8” (3mm)
increments, up to the strip mark on
the buffer. If the fiber breaks during
this process, rotate the fiber slightly to
make new marks on the buffer and
start the strip process over again.
Step 6:
Clean the bare fiber using a dry
wipe and approved cleaning solution.
Note
: DO NOT use pre-moistened wipes.
Note:
Observe appropriate fiber safety precautions.
Step 7:
Cleave the bare fiber to 7mm.
Tip:
You can verify the cleave length using the stripping template.
FSPCVR:
Press the metal square on the right side of the cleave tool
all the way to the left until the blade locks in place.
FSPCVR:
Align the end of the buffer with the 7mm mark on the
cleaver, then close the lid to complete the cleave process.
Strip Mark
Insertion Mark
