© Panduit Corp. 2022
FS132E
1
OptiCam® 2 Termination Tool Quick Start Guide
© Panduit Corp. 2022
WARNING
Read and understand the instructions and safety information in this manual
before operating this tool.
Failure to observe this warning can result in bodily injury.
Warning
: Risk of fire. Battery can explode or leak and cause injury if installed
backwards, disassembled, charged, crushed, or exposed to fire or high
temperature.
CAUTION
Caution
- Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure. The laser is emitted from the LC connector located at the top
of the tool.
•
Never
point the laser into the eyes of others.
•
Do Not
stare directly at the laser beam.
•
Do Not
set up tool to work at eye level or operate the tool on a
reflective surface as the laser could be projected into your eyes or
the eyes of others.
Viewing the laser output with certain optical instruments (for example,
eye loupes, magnifiers, and microscopes) within a distance of 3.9” (99
mm) may pose an eye hazard.
Remove the batteries when storing for an extended period to avoid
damage to the tool should the batteries deteriorate.
TECHNICAL INFORMATION
Recommended Use:
With available launch cords and cradles only
Laser Diode Type:
IEC 60825-1 Class 1 Laser product
Connectors:
Panduit LC, SC, ST, singlemode and multimode,
OptiCam connectors only
Power Supply:
2 size AA (type L91) 1.5volt Lithium Iron Disulfide
batteries, Max Discharge: 2.5 amp continuous,
included. Size AA alkaline batteries can be used at
a reduced rate battery life.
Tool can also be powered without batteries
through the power/data (5 VDC, 1 amp max) port
on the side of the tool.
Rated Battery Life:
Approximately 8 hours (continuous use)
Firmware Updates:
Use power/data port on the side of the tool to
connect to PC, visit
for latest
firmware
Environment:
FOR INDOOR USE ONLY
Max altitude 2000m
Pollution degree 2
Operating Temperature:
+32° F to +104° F (0° C to +40° C), <93% RH, non-
condensing
Storage Temperature:
-40° F to +158°F (-40°C to +70°C)
Overall Dimensions:
2.1" H x 2.8" W x 9.1" L (53mm x 71mm x 231mm)
Weight:
9.0 oz (255 g) without batteries
Tool Storage
After all connector terminations are complete, detach the launch cord from the tool by disconnecting the LC connector at the top of the tool. Detach
the ferrule adapter from the cradle and put dust caps on both ends of the launch cord. Place tool, launch cord, and cradle in a protective case.
Care and Handling
•
Laser tools are precision instruments, which should be handled with care.
•
Avoid shock, vibrations, and extreme heat.
•
Avoid dust and water that could obstruct laser.
•
Keep tool dry and clean.
•
Check batteries regularly to avoid deterioration.
•
Remove batteries if the tool is to be stored for an extended period.
Tool Maintenance
•
This tool contains no user serviceable parts.
•
The laser output is not user adjustable.
•
Contact Panduit Corp. for service needs.
Symbols
This symbol indicates the need for separate collection of electrical and electronic equipment waste.
Separating electronic waste can halt the potential adverse effects on the environment and human health because of the hazardous substances in
electrical and electronic equipment. This waste should be returned to the proper collection facility.
当該機器には電波法に基づく、技術基準適合証明等を受けた
特定無線設備を装着している。
OptiCam 2
